Full 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the truck arrives.
Before
After
Before
After
Before
AfterGarage Door Before & After in West Palm Beach, FL
We could spend paragraphs telling you how careful our technicians are. But a before-and-after shot of a torsion spring swap or a full door replacement says it in two seconds. On every job since 2015, we’ve photographed the failed part and the finished work. Those photos go to the customer, per Clause 4 of The Haven Standard. Below is what that looks like across West Palm Beach, from South End to Northwood Hills.
Recent Transformations
Torsion Spring Replacement in Flamingo Park
[Photo placeholder: Broken torsion spring, gap visible at coil, door hanging uneven]
[Photo placeholder: New matched spring pair installed, door balanced, level]
The homeowner called at 7:15 a.m. because the door wouldn’t open and the car was inside. Our technician measured the failed spring at 0.225-inch wire diameter. It had snapped clean at the coil, which happens on average every 8 to 12 years in South Florida’s humidity. We replaced both springs, not just the broken one – the other had the same cycle count and would’ve failed within months. Total time on site: 82 minutes. The customer got a documented photo record of the broken spring before we touched anything, and a written price before we started.
Full Door Replacement in Old Northwood
[Photo placeholder: Rusted steel door, dented bottom panel, vertical track out of square]
[Photo placeholder: New Clopay door in a traditional raised-panel style, fresh hardware, new weatherstripping]
A salt-air corrosion case. This Old Northwood home sits close enough to the Intracoastal that the original steel door had rusted through at the bottom rail. The hinge brackets were still fine, but the door skin was gone. We measured the opening, quoted a full Clopay replacement with new vertical tracks and a fresh bottom seal, and set a date – no same-day install promises on a door that has to be ordered to size. The old door test-failed our safety inspection. We advise any West Palm Beach homeowner with rust visible on a door’s bottom panel to get it looked at before the panel detaches from the hinge line.
Garage Door Opener Replacement in South End
[Photo placeholder: Original opener with cracked logic board housing, loose trolley carriage]
[Photo placeholder: New LiftMaster opener mounted, new safety sensors at rail base]
The logic board was the culprit here, the circuit board inside the opener that translates your remote’s signal into motor action. This one had a hairline crack invisible until the board was pulled and inspected. Rebuilding a 9-year-old opener on a worn trolley carriage is bad money. We quoted a new LiftMaster unit and told the customer the failure cause before ordering anything. The old machine’s open-limit switch had also drifted, which is why the door would reverse at half height. New opener, new sensors, new travel limits set and tested.
Roller and Hinge Replacement in Villages of Palm Beach Lakes
[Photo placeholder: Nylon roller with flat spot, hinge pin backing out]
[Photo placeholder: New nylon rollers in all 10 positions, hinge pins secure]
This one sounded like a cement mixer. The customer in the Villages of Palm Beach Lakes told us the door “rumbled” every time it moved. Two nylon rollers had flat spots the size of a quarter, and a center hinge pin had backed out far enough to scrape the track. We replaced all ten rollers rather than patching the two bad ones – with the door already down, the marginal labor cost beats a second service call in six months. The customer’s photo record shows each failed roller before we unbolted them. The door now opens at conversational volume, which is roughly how it should sound.
Emergency Cable and Safety Inspection in Roosevelt Estates
[Photo placeholder: Frayed lift cable, strands separated, door barely holding at angle]
[Photo placeholder: New cable pair installed, door rebalanced, track alignment checked]
We treat a frayed lift cable as an emergency, because it is one. The cable is what keeps the door from free-falling when a spring lets go. This Roosevelt Estates call started as a routine “door feels heavy” note. The technician found the left cable down to 40 percent of its strand count. High-tension cables are not a DIY fix – when they snap under load, the recoil can cause serious injury. We replaced the cable pair, rebalanced the door, and verified the spring tension matched the door weight. The customer received photos of the fray before we cut anything.
Want Results Like These?
Every job above was priced in writing before the first tool came off the truck. If your door is showing age, making noise, or refusing to move, call (561) 489-7509. A real person answers, 24/7, including holidays. We serve West Palm Beach and the surrounding area with a technician who’ll introduce himself by name and photograph what he finds.
Written by Marcus Deller, Owner at Servo Garage Doors West Palm Beach, serving West Palm Beach since 2015.