Full 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the truck arrives.
Before
After
Before
After
Before
AfterAmarr Weather Seal Replacement: The West Palm Beach Owner’s Guide
We stock and install Amarr-compatible replacement weather seal on our trucks, with most West Palm Beach jobs running $110-$220 installed for a standard 16-foot residential door. That price includes the new seal, removal of the old material, and a documented photo record of the finished work before we leave. Most owners discover the failure the same way: a strip of rubber sagging from the bottom of the door, or daylight visible under a closed panel after a storm.
The weather seal on an Amarr door is not decorative. It keeps rainwater, leaves, insects, and the humidity that defines South Florida summers from moving into your garage. When it fails, you’ll usually see it before you feel it: the seal develops a flat spot, pulls away from the aluminum retainer channel, or shreds at the corners where the door meets the track.
Which Amarr Models This Applies To
Amarr builds residential doors across several series: Classica, Heritage, Lincoln, Oak Summit, and the commercial-grade Stratford lines. The weather seal itself is more standardized than the door, which is good news. Amarr residential doors take a T-style or bulb-style bottom seal that slides into a U-shaped aluminum retainer mounted along the bottom panel, plus vinyl perimeter seals along the jambs and header. Most Amarr doors from the last 20 years use the same 3/8-inch or 5/16-inch T-channel profile, but there’s a gotcha worth knowing: the Stratford and some Classica steel-backed models use a wider retainer that takes a 1/2-inch bulb seal, not the standard T.
If you’re identifying your own part before calling, the tag on the interior side of the door near the top panel carries the model and serial. If that’s missing or faded, measure the retainer opening: a standard T-channel measures 3/8 inch across the mouth. For OEM versus aftermarket: Amarr OEM seals are priced higher and are, in our experience, not meaningfully better than a quality aftermarket equivalent in the same profile and durometer. We install both, quote the difference, and document which one goes on your door.
We also stock parts for LiftMaster, Chamberlain, and Genie openers, so if the bottom seal is part of a bigger issue, we can address it in one visit.
Signs Your Amarr Weather Seal Is Failing
- Water on the garage floor after rain. West Palm Beach gets roughly 60 inches of rain a year, much of it sideways. A seal that’s flattened or pulled free lets water travel under the door and pool near the interior wall.
- Visible daylight under the closed door. This is the most common call we get. If you can stand inside the garage with the lights off and see light along the bottom, the seal has compressed past the point of recovery or pulled out of the retainer.
- Leaves, sand, or debris inside near the door track. Palm fronds and coastal sand get driven under doors with worn seals. This is not just cosmetic; sand accelerates wear on the roller tracks.
- The seal is cracked, brittle, or missing a chunk at the corner. UV exposure breaks down rubber here faster than almost anywhere in the country. A seal that’s gone hard in one area will tear completely along that weak point.
- Higher garage temperature and humidity. Once the seal begins leaking air, Florida humidity enters the garage, driving up ambient temperature and creating conditions for mildew on stored items.
BeforeAfterReplacement Cost & What’s Included
In West Palm Beach, we quote $110-$220 installed for Amarr-compatible weather seal replacement on standard residential doors. The spread is driven by three things: door width, whether we’re replacing just the bottom seal or the full perimeter, and whether the aluminum retainer channel has been damaged and needs replacement. A 16-foot door with a clean retainer lands at the lower end; a 9-foot-wide door with rotted jamb seals and a bent retainer lands higher.
Every quote is a flat, written price with a written scope, per Clause 1 of The Haven Standard, delivered before any work starts. The price you approve is the price on the invoice. That’s not a courtesy; it’s the entire operating agreement. The new seal carries a 365-day warranty on parts and labor through our Done Right Promise: if it’s not right, we make it right.
DIY or Call Us?
Replacing an Amarr weather seal is one of the safer garage door jobs to attempt. The part is not under tension, and the retainer channel slides apart without special tools. But where owners consistently go wrong is in the details: buying a 3/8-inch T-seal for a Stratford that requires 1/2-inch bulb stock, trimming the seal too short at the ends so water gets through the corners, or stripping the screws on a corroded retainer and leaving it hanging half-attached. In coastal air, the retainer screws are often the first thing to fail, and a stripped aluminum channel makes the repair worse than the original problem.
If the door itself is misaligned, a new seal will wear unevenly and fail within months. That’s the real reason to have us look: we’ll tell you if the seal is the whole story or if the door is dragging against the track. Call (561) 489-7509 and we’ll give you a flat written price before anything gets touched.
FAQs
Three to five years is typical in our climate, with UV exposure and salt air cutting the lifespan shorter on doors that face east or west. Doors that face north or are shaded by a porte-cochère can get seven years. The visible signs of age are the best indicator, not the calendar. Call us at (561) 489-7509 and we can tell you over the phone whether yours is past saving or has life left.
In practice, no. Small tears can be glued temporarily, but the material has lost its flexibility at that point and the repair rarely lasts more than a few months in Florida heat. Replacement is the honest fix, and it costs less than most people assume.
A straightforward bottom seal replacement takes 30 to 45 minutes on site. A full perimeter job with jamb seals and header seal runs closer to 90 minutes. We carry the standard Amarr profiles on the truck, so the work is usually done in one visit, same day.
Yes. We stock standard 3/8-inch and 5/16-inch T-channel bottom seals, 1/2-inch bulb stock for Stratford and steel-backed Classica models, and perimeter vinyl in common heights. If your door requires a non-stock profile, we’ll have it within one business day and show you the written price for it before ordering. Estimates are free; call (561) 489-7509.
Contact Servo Garage Doors West Palm Beach
If your Amarr weather seal is failing, we’ll name the part, quote the range, and do the work. Every job is quoted with a flat written price before we touch the door, backed by The Haven Standard and our 365-Day Done Right Promise. Call (561) 489-7509 for a free estimate, answered by a person, 24 hours a day. Or if you have a written estimate from another company, bring it in and we’ll give you a free second opinion on it.
Written by Marcus Deller, Owner, Servo Garage Doors West Palm Beach at Servo Garage Doors West Palm Beach, serving West Palm Beach and nearby areas.